This command displays the PFC watchdog status.The hardware supports PFC on priorities 0 1 2 3 4 5 6 7 This command displays the PFC status on all.Switch(config)# priority-flow-control pause watchdog default polling-interval 20 Switch(config)# priority-flow-control pause watchdog default recovery-time 30 forcedġ/1, and configures a PFC polling-interval of Switch(config)# priority-flow-control pause watchdog default timeout 10ġ/1, and configures a PFC forced recovery-time interval ofģ0 seconds after which the stuck queue(s)Īre recovered, irrespective of whether PFC frames are being received or
Switch(config-if-Et1/1-txq-3)#bandwidth guaranteed 100 Switch(config-if-Et1/1)#priority-flow-control priority 3 no-drop Switch(config-if-Et1/1)#priority-flow-control on These commands enable the pfc-watchdog monitoring on tx-queueġ/1, and configures a PFC congestion timeout of.The platform fm6000 pfc-wm command must explicitly configure at least one parameter. The no platform fm6000 pfc-wm and default platform fm6000 pfc-wm commands restore the default settings by removing the platform fm6000 pfc-wm command from running-config. Value must be greater than the off value, which must be Values that are entered in the command are rounded up to the closest multiple of The command provides options to configure theīuffer size and specify when PFC frames are sent to request that a neighbor stop The platform fm6000 pfc-wmcommand configures the hardware buffer space allocated to the Priority FlowĬontrol (PFC) RX-Private buffer.